HORIBA

HORIBA TW-150 Water distribution monitor

HORIBATW-150Water distribution monitorSpecifications:Product nameWater Distribution MonitorTypeTW-150Measurement items(Standard configuration) turbidity, color, free residual chlorine, water pressure,

  • model:

HORIBA

TW-150

Water distribution monitor


Specifications:

Product name

Water Distribution Monitor

Type

TW-150

Measurement items

(Standard configuration) turbidity, color, free residual chlorine, water pressure, pH
(Optional items) conductivity, water temperature

Measurement Method

See Table 1.

Measurement  Range

See Table  1.

Repeatability

See Table  1.

Display system

LCD display
320 x 240 dot backlit change to five graphic liquid-crystal display (touch panel type)
Up to seven items including five items from standard configuration (turbidity, color, free residual chlorine, water pressure, pH)
and optional items (conductivity, water temperature) can be displayed at the same time.

Calibration method

See Table 1.

Automatic zero calibration

(Turbidity, color, free residual chlorine)
Calibration method: Filtrate sample water
Calibration start: Interior…started by internal timer
       Exterior...started by external contact input
Calibration cycle: 5 hours to 9999 hours (user setting)
Calibration time: Approx. 15 minutes

Automatic cleaning

(Turbidity, color)
Cleaning method: Cell window cleaning using wiper
Cleaning start: Interior...started by internal timer
       Exterior...started by external contact input
Cleaning interval: 5 to 9999 minutes (user setting)
(Free residual chlorine)
Continuous cleaning by using grinding beads

Automatic draining

Draining start: Interior...started by internal timer
Draining interval: 5 to 9999 minutes (user setting)

Sample water condition

Temperature: 0°C to 40°C (do not freeze)
Pressure: 0.1 MPa to 0.75 MPa
Conductivity: 10 mS/m or higher
Analyzing unit input rate (flow rate): 50 mL/mi to 100 mL/min
● In test operation, flush the meter thoroughly before running water.
● Make sure to set up a bypass for piping to the meter.
● If sample water may freeze, take measures to insulate the unit from cold and to retain heat.
● Sample Water measured with this device cannot be distributed.

Ambient temperature,humidity

Ambient temperature: 0°C to 40°C
Ambient humidity: 85% or lower

Analog output

Type: Measurement values: Number of outputs corresponds to number of measurement values (up to seven values including five values of the standard configuration)
Specifications: 4 mA to 20 mA DC, insulated output (non-insulated between items)
Maximum load resistance: 600 Ω

Contact output

Types: Power failure, batch alarm, maintenance
Contents: Power failure…occurs when the power is turned off
     Batch alarm…cell temperature adjustment abnormality, temperature compensation abnormality,
           cell wiper abnormality internal communication abnormality, leak, battery abnormality,
           concentration upper limit concentration lower limit,concentration device upper limit,
           concentration device lower limit, light source abnormality zero calibration, span calibration, analyzer abnormality
     Maintenance…when the system enters maintenance or calibration mode
Specifications: No-voltage contact output, a contact interface
     Contact rating: 125 V AC 0.3 A, 30 V DC 1 A (at resistance load)
     Each output is an independent COM interface.


首页
产品
新闻
联系